RT-4410-5

RT-4410-5 is a PVC rafter tail with a deep slanted step about a third of the way out, after which the underside sweeps up in a full, bowed curve that eases off toward the square tip. The deep cut gives the curve a bold, confident start. Sold in nine standard sizes for HB’s soffit system or independent use.

SKU: RT-4410-5 Category: Tag:
Description

RT-4410-5 PVC Rafter Tail 

The size of the cut that starts a curve changes its character. A shallow notch reads as a fine accent, while a deep step makes the curve look carved out of a heavy timber. RT-4410-5 takes the bolder route. Like all HB tails, it is cellular PVC trim that recreates exposed rafter ends without being part of the roof structure.  

A deep step and a full curve 

For roughly a third of its length RT-4410-5 is a plain, full-height block. A deep slanted step then removes a good share of the underside in one cut, and from there a bowed curve climbs steeply at first and flattens as it nears the end, which finishes square beneath the straight top edge. 

Several tails use this bowed curve. RT-4402-4 starts it with a much smaller square notch, and RT-4401-5 with a simple angled break. RT-4410-7 uses the same deep step set closer to the wall. RT-4410-5 suits larger coastal, Mediterranean and British West Indies homes, and can also serve as a gable lookout or a detail beneath a deck.  

Construction 

HB Elements fabricates RT-4410-5 in hollow-core cellular PVC on its patented system. It is a decorative component and must not be used to carry loads. 

A cleat and adhesive are packed with the tail. If your overhang is shallow, it can be trimmed on site, then fixed against cellular PVC soffit or over stucco, wood or cement fiber. It takes paint after light preparation.  

With HB soffit panels 

The bold curve reads clearly against the fine grooves of a nickel joint ceiling such as NJP-SL-5-08, and each tail hides a panel seam where it sits. HB fascia and frieze board complete the soffit ceilings system; tails are also sold on their own.

Ordering and sizing help 

HB will size the tails from your drawings: email a PDF to info@hbelementsinc.com or call (954) 784-8216. The Rafter Tails Spec Sheet sets out standard dimensions, and the rafter tails page compares every profile.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″