

RT-4701-7
RT-4701-7 is a PVC rafter tail with a deep scooped curve that rises from near the wall, then rolls over a rounded shoulder down into a deep square end. No steps or notches. The heavier end gives it a corbel-like look. Nine standard sizes for HB soffit systems or standalone use.
RT-4701-7 PVC Rafter Tail
Where most waved tails thin toward the tip, RT-4701-7 does the opposite: its underside scoops up and then turns back down, so the end finishes deep and solid. The shape recalls a carved corbel at the eave. Like the rest of the range, it is a decorative cellular PVC tail rather than a structural one.
Scoop, shoulder and a deep end
From about a fifth of the way out, the underside of RT-4701-7 climbs in a long, deep scoop. Past the midpoint the curve rolls over a rounded shoulder and descends again, meeting a square end that is noticeably deeper than the middle of the tail. The top edge stays straight throughout.
Set beside RT-4700-5, which levels out instead of turning down, the difference is the weight at the tip. RT-4705-6 has a similar heavier end but adds a hooked notch near the wall. The corbel-like profile suits Mission, Spanish Colonial and Craftsman homes, and porch or entry roofs.
Material
RT-4701-7 is cellular PVC with a hollow center, made on HB Elements’ patented system. Despite its solid appearance at the end, it is trim and carries no load.
Use the supplied cleat and adhesive to install it. The tail can be trimmed for a shorter overhang and attached to PVC soffit, stucco, wood or cement fiber, then painted after light surface prep.
Combining with HB panels
Beneath a slatted nickel joint soffit such as NJP-SL-5-08, the deep tail ends give the eave a strong rhythm against the fine panel lines, and the tails conceal seams. HB fascia and frieze board are available in the same soffit ceilings group; tails are sold separately too.
Ask HB about sizing
For a size proposal, send PDF elevations or sections to info@hbelementsinc.com or call (954) 784-8216. See the Rafter Tails Spec Sheet for standard dimensions and the HB rafter tails page for related designs.
