RT-4293-7

RT-4293-7 is a PVC rafter tail with three square steps set close to the wall, followed by a long, shallow concave curve that ends in a notch under the square tip. Moving the steps inward leaves most of the tail for the curve, producing a long, layered silhouette. Nine sizes for HB soffit systems or standalone use. 

SKU: RT-4293-7 Category: Tag:
Description

RT-4293-7 PVC Rafter Tail 

Starting the detail near the wall changes how a stepped rafter tail reads: the steps become a base, and the rest of the tail turns into a long, sweeping line. RT-4293-7 is designed this way. It is a non-structural cellular PVC tail that recreates the look of exposed rafter ends along the eave. 

Early steps, long curve 

A short distance from the wall, three small square steps lift the underside of RT-4293-7 in a quick sequence. A long, shallow concave curve then rises across most of the remaining length and finishes at a notch, leaving a small ledge under the square tip. 

Compared with RT-4293-4, which sets its three steps around mid-length, RT-4293-7 trades some solid body for a longer curve. RT-4270-8 has a similar long curve and notch with a single step. RT-4293-7 suits deep, low eaves on coastal and West Indies homes, and also works at gable ends or under cantilevered decks. 

Material 

RT-4293-7 is cellular PVC around a hollow core, made on HB Elements’ patented fabrication system. It is purely decorative. 

A cleat and adhesive come with the tail. Trim it on site if needed, then fix it to cellular PVC soffit, stucco, wood or cement fiber; it paints with minimal preparation. 

Using it with HB soffit panels 

Over a grooved ceiling such as the NJP-5-08 nickel joint panel, the long curves balance the straight grooves, and the tails hide joints between panels. HB fascia and frieze board finish the PVC soffit system; tails can also be purchased separately.

Ordering and sizing help 

Send HB a PDF of the plans at info@hbelementsinc.com and call (954) 784-8216 to confirm sizes. Standard sizing is in the Rafter Tails Spec Sheet; the HB rafter tails page shows related designs. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″