NJP-5-08

NJP-5-08 is an 8-foot, 1/2″ thick cellular PVC soffit panel with square-cut nickel joint grooves spaced 5″ on center. It gives porch ceilings and roof overhangs the clean, crisp lines of board-style soffit without the upkeep of wood, and comes in seven widths from 12″ to 48″.

SKU: NJP-5-08 Category:
Description

NJP-5-08 Nickel Joint PVC Soffit Panel (8 ft) 

A nickel joint panel imitates individual boards laid side by side, but instead of the angled V between boards, each joint is a small, flat-bottomed channel with square shoulders. The result is a tailored, contemporary take on traditional board ceilings. NJP-5-08 is HB Elements’ nickel joint panel in an 8-foot length, the shortest of the three lengths HB produces.  

What the nickel joint looks like 

The grooves on NJP-5-08 run along the length of the panel at 5″ spacing, so each panel reads as a series of narrow boards similar to 1×6 tongue and groove. The surface between the grooves is smooth rather than embossed, so it does not imitate any particular wood species. HB lists nickel joint groove widths of 1/8″, 1/4″, 3/8″ and 1/2″; confirm the width you want when ordering. 

If you prefer the softer shadow line of a beveled joint, the V-groove equivalent is VGP-5-08. For a stepped, overlapping-board look, see the shiplap version, NJP-SL-5-08.  

Why choose an 8-foot panel 

Eight-foot lengths are easier to carry, lift overhead and hold in place on a ladder than longer sheets, which helps on smaller crews and tight porches. They suit short runs such as entry porches, covered patios, breezeways and the soffit beneath a dormer or bay window, as well as accent walls, where HB notes the panels can be installed vertically or horizontally. 

For long, uninterrupted eaves where you want fewer end joints, the same panel is made in 10-foot (NJP-5-10) and 12-foot (NJP-5-12) lengths.  

Material and installation 

The panel is made from cellular PVC, which HB states will not split, check, crack or rot and resists moisture and mildew. It is cut and fastened with ordinary woodworking tools. Fitted with HB PVC rafter tails, the panel seams are hidden and few fasteners are left exposed, so little preparation is needed before painting. HB also offers a factory-applied woodgrain finish in several stain colors for its soffit panels. Fascia, frieze board and rafter tails complete the HB PVC soffit system, and each part can be bought separately.

Ordering and sizing help

Email a PDF of your plans to info@hbelementsinc.com, then call (954) 784-8216 to go over widths, groove size and quantities with the HB team. Full details are in the Soffit Panels Spec Sheet.

Additional information
soffit-systems-variationsNickel joint panel – 1/2″ x 12″ x 8′, Nickel joint panel – 1/2″ x 18″ x 8′, Nickel joint panel – 1/2″ x 24″ x 8′, Nickel joint panel – 1/2″ x 30″ x 8′, Nickel joint panel – 1/2″ x 36″ x 8′, Nickel joint panel – 1/2″ x 42″ x 8′, Nickel joint panel – 1/2″ x 48″ x 8′