

RT-4270-8
RT-4270-8 is a PVC rafter tail with a small slanted step just out from the wall, a long concave arc across most of its underside and a crisp notch with a small ledge under the square tip. The early start makes the arc long and shallow. Nine sizes for HB soffit systems or standalone use.
RT-4270-8 PVC Rafter Tail
Stretching an arc across nearly the whole length of a rafter tail makes it look lighter and longer from below. RT-4270-8 does this, then finishes the arc with a sharp notch so the tip stays well defined. It is a decorative tail in cellular PVC; it reproduces exposed rafter ends and plays no structural role.
A long arc with a notched finish
RT-4270-8 keeps full height only for a short distance from the wall. A small slanted step there starts a long, shallow concave arc that climbs over most of the tail. Just before the end, the arc stops at a notch, leaving a short ledge and a square tip under the straight top edge.
Its sibling RT-4270-4 starts the same arc about a third of the way out, giving a shorter, deeper curve. For a similar long arc and notch with no step at the start, see RT-4260-7. RT-4270-8 is a good choice for wide overhangs on coastal and Key West homes, and can also be used at gable ends or under a cantilevered deck.
Material
HB Elements forms RT-4270-8 in cellular PVC with a hollow core, using the patented system behind all its rafter tails. It is non-structural and meant only as trim.
Each tail ships with a cleat and adhesive. Cut it down if the overhang calls for it, then attach it to cellular PVC soffit, stucco, wood or cement fiber. Painting needs only light preparation.
With HB panels
Set over a nickel joint ceiling such as NJP-SL-5-10, the long arcs contrast with the straight grooves, and the tails hide the joints between panels. Add HB fascia and frieze board for a complete PVC soffit system, or order the tails on their own.
Ordering and sizing help
Email your plan set to info@hbelementsinc.com as a PDF and follow up on (954) 784-8216 to confirm sizes. Standard sizing is in the Rafter Tails Spec Sheet; compare profiles on the HB rafter tails page.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
