

RT-4202-6
RT-4202-6 is a PVC rafter tail with a small square notch close to the wall, from which a long concave curve sweeps up the underside to a square tip. Starting the curve so early lets it run almost the full exposed length of the tail, for a long, graceful line. Nine sizes, for HB soffit systems or standalone use.
RT-4202-6 PVC Rafter Tail
Where the curve of a rafter tail begins makes a big difference to how it looks from below. RT-4202-6 starts its curve almost at the wall, marked by a small notch, so the sweep stretches across nearly all of the visible tail. It is a decorative cellular PVC piece that recreates exposed rafter ends; the structural framing remains concealed.
An early notch and a long curve
Only a short section near the wall keeps the full depth. There, a small square notch steps the underside up, and from that point a long concave curve rises steadily along the tail, finishing at a short square face at the tip under a straight top edge.
It is a longer-curved version of RT-4202-3, which places the notch around mid-length and gives a shorter, deeper sweep. For the same concave curve with no notch at all, see RT-4201-3. RT-4202-6 suits wide, shallow eaves on coastal, Key West and West Indies homes, and can also be used at gable ends or under a cantilevered deck.
How it is made
RT-4202-6 is hollow-core cellular PVC, made on HB Elements’ patented fabrication system. It is purely decorative and should not be used structurally.
A cleat and adhesive are packed with each tail. Shorten it on site if needed, then attach it to cellular PVC soffit, stucco, wood or cement fiber. It needs only minimal prep before painting.
Completing the soffit
Run RT-4202-6 over HB panels such as the VGP-SL-5-12 shiplap V-groove panel to hide panel joints and add a flowing, timber-framed rhythm. HB fascia and frieze board finish the PVC soffit system, and the tails can also be ordered alone.
Ordering and sizing help
Share your plans with HB as a PDF at info@hbelementsinc.com or call (954) 784-8216 to agree sizes. The Rafter Tails Spec Sheet lists standard dimensions, and the rafter tails collection shows more profiles.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
