NJP-5-10

NJP-5-10 is HB Elements’ 10-foot nickel joint soffit panel: 1/2″ cellular PVC with flat-bottomed grooves every 5″, for a crisp board-ceiling look under eaves and porch roofs. The mid-length panel covers more ground per piece than an 8-foot sheet while staying manageable overhead. Seven widths, 12″ to 48″.

SKU: NJP-5-10 Category:
Description

NJP-5-10 Nickel Joint PVC Soffit Panel (10 ft) 

At 10 feet, NJP-5-10 sits in the middle of HB’s three soffit panel lengths. It is long enough to cover typical eave and porch spans with fewer end joints than an 8-foot panel, yet shorter and lighter to position overhead than a 12-foot one. That balance makes it a practical default for many residential soffit jobs.  

Square grooves for a tailored finish 

Nickel joint panels get their character from the shape of the groove. Rather than a beveled V, each recess has straight sides and a flat base, casting a sharp, even shadow line. On NJP-5-10 these recesses are spaced 5″ apart, echoing the board rhythm of 1×6 tongue-and-groove ceilings. Between the grooves the face is smooth with no printed grain, ready for paint. HB makes nickel joint grooves 1/8″, 1/4″, 3/8″ or 1/2″ wide, so tell the team which you need. 

Prefer a beveled joint? Choose the V-groove VGP-5-10. For overlapping board edges, the shiplap version is NJP-SL-5-10.   

Planning the layout with 10-foot lengths 

Before ordering, measure each run of soffit and decide which way the grooves will run. Ten-foot panels divide evenly into 20- and 30-foot runs, and because each sheet is a single piece across its full width, there is no long joint to caulk. Where end joints are needed, HB rafter tails help conceal the panel seams. 

Working on a short porch or a tight space? The 8-foot NJP-5-08 is easier to handle. On long, straight eaves, the 12-foot NJP-5-12 reduces joints further.  

Built from cellular PVC 

Like all HB soffit panels, NJP-5-10 is cellular PVC, a material HB describes as impervious to moisture, mildew and rot, and that will not split, crack or warp the way exposed wood can. It is worked with standard woodworking tools and holds paint well. Combine it with fascia, frieze board and HB PVC rafter tails for a complete PVC soffit ceiling, or use it alone, including as wall cladding.

Ordering and sizing help 

Share your plans as a PDF with info@hbelementsinc.com and call (954) 784-8216 to confirm widths, groove size and the number of panels for each run. Specifications for all HB soffit panels are in the Soffit Panels Spec Sheet. 

Additional information
soffit-systems-variationsNickel joint panel – 1/2″ x 12″ x 10′, Nickel joint panel – 1/2″ x 18″ x 10′, Nickel joint panel – 1/2″ x 24″ x 10′, Nickel joint panel – 1/2″ x 30″ x 10′, Nickel joint panel – 1/2″ x 36″ x 10′, Nickel joint panel – 1/2″ x 42″ x 10′, Nickel joint panel – 1/2″ x 48″ x 10′