

RT-4005-7
RT-4005-7 is a PVC rafter tail in three clear stages: a square notch about a third of the way along the underside, a short level run, then a long angled cut up to a square tip. The spacing between notch and slope gives the end a measured, stepped look. Nine sizes, for the HB PVC Soffit System or standalone use.
RT-4005-7 PVC Rafter Tail
Rafter tails with a stepped underside were a common way to dress up exposed roof framing, and the spacing of the cuts decided how busy or calm the end looked. RT-4005-7 spaces its details out evenly along the underside, giving the eave a rhythmic, crafted appearance. It is a decorative PVC tail that replicates exposed rafter ends without forming part of the roof structure.
Notch, level run, slope
The top edge of RT-4005-7 stays straight from wall to tip. Underneath, the full-depth body ends roughly a third of the way along at a small square notch. A short level stretch follows, and then the underside angles upward in a long straight line, covering close to half the tail, to finish at a short vertical face.
The level stretch between notch and slope is what sets this tail apart. On RT-4004-3 the slope begins right after the notch, while RT-4011-5 has a longer level run and a shorter, steeper end cut. RT-4005-7 sits in the middle, balanced and evenly spaced. It suits coastal, West Indies and Florida Vernacular homes, and works equally as a gable lookout or beneath a cantilevered deck. A related profile, RT-4005-9, is also available.
Material and fixing
RT-4005-7 is made from cellular PVC with a hollow core using HB Elements’ patented fabrication system. It is an architectural accent and should never be relied on structurally.
The supplied cleat and adhesive make fixing simple, and the tail can be cut to a shorter length on site. Mount it over stucco, wood, cement fiber or, most commonly, cellular PVC soffit. It needs little surface prep before painting.
Use with HB soffit panels
Set along a soffit lined with HB panels such as the VGP-5-12 V-groove panel, RT-4005-7 helps cover the panel seams and gives the ceiling a timber-framed character. Add fascia and frieze board to complete the HB PVC soffit system, or order the tails on their own.
Ordering and sizing help
Send HB a PDF of your plans at info@hbelementsinc.com or call (954) 784-8216 to agree sizes. Dimensions for all standard tails are in the Rafter Tails Spec Sheet; browse more shapes on the rafter tails page.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
