RT-4620-2

RT-4620-2 is a PVC rafter tail that stays plain for more than half its length, then drops a slanted step and climbs a short, steep S-curve to a slim square tip. Nine standard sizes, for HB soffit systems or standalone eaves. 

SKU: RT-4620-2 Category: Tag:
Description

RT-4620-2 PVC Rafter Tail 

Some rafter tails spread their shaping along the whole member; RT-4620-2 holds it back. The straight underside reads as a plain beam until the last stretch, where a slanted step and a tight S-curve turn the end into the focal point. It is a decorative cellular PVC piece, not structure. 

A late step and a steep curve 

Past the midpoint of RT-4620-2, the straight underside ends at a slanted step. Beyond it the profile climbs a compact S-curve, steeper than most in the range, and finishes at a slim square tip under the straight top edge. There is no notch at the tip itself. 

Compared with RT-4601-2, which also keeps its curve near the end but has no step, RT-4620-2 adds a sharp break before the wave. RT-4670-3 starts its step a little earlier and adds a notch at the tip. The restrained body suits Craftsman and coastal homes where only the ends should catch the eye. 

Construction and installation 

The tail is cellular PVC with an open core, made by HB Elements on its patented production process. It dresses the eave and has no load-bearing role. 

Every RT-4620-2 ships with a cleat and adhesive for fixing. You can cut it back for a shorter projection and mount it on cellular PVC soffit, stucco, wood or cement fiber; once wiped clean it accepts paint. 

With HB soffit ceilings 

Beneath a slatted V-groove ceiling like VGP-SL-5-10, the plain tail bodies line up with the grooves and the stepped ends stand out at the fascia. The tails mask panel seams, and HB fascia and frieze board are part of the same soffit ceilings offering. Standalone orders are fine too. 

Sizing support 

For a recommendation, send drawings (elevations or sections, PDF) to info@hbelementsinc.com or phone (954) 784-8216. The Rafter Tails Spec Sheet lists standard dimensions, and related profiles are gathered on the HB rafter tails page. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″