RT-4670-3

RT-4670-3 is a PVC rafter tail with a plain inner half, a slanted step at about mid-length and an S-curve that rises to a notch under the square tip. A cut at each end of the wave frames it. Nine standard sizes for HB soffit systems or standalone eaves. 

SKU: RT-4670-3 Category: Tag:
Description

RT-4670-3 PVC Rafter Tail 

RT-4670-3 brackets its wave with two cuts: a slanted step where the curve begins and a notch where it ends. The plain inner half keeps the tail calm near the wall, so the framed curve becomes the detail people notice. It is a non-structural cellular PVC tail that recreates the exposed rafter look. 

A framed S-curve 

The underside of RT-4670-3 stays straight to about the midpoint, where a slanted step drops it down. A short level stretch leads into an S-curve that climbs to the end, finishing in a notch cut beneath the square tip under the straight top edge. 

It is the shorter cousin of RT-4670-7, which starts its step closer to the wall and stretches the curve further. RT-4620-2 has a similar late step but ends without a notch, and RT-4660-3 keeps the tip notch but drops the step. The framed wave fits Mission, Spanish and coastal elevations as well as carports and loggias. 

How it is built 

Cellular PVC with a hollow core forms the body, made under HB Elements’ patented process. RT-4670-3 is there for looks; it should not be used to bear weight. 

A cleat and adhesive come with each tail. Saw it to a shorter length if the eave requires, then secure it to PVC soffit, stucco, wood or cement fiber. Little prep is needed before painting. 

Combining with soffit panels 

Under a nickel joint ceiling like NJP-5-10, the tails run across the panel lines and conceal the seams, while the framed curves give the eave rhythm. Add HB fascia and frieze board from the soffit ceilings selection, or order the tails alone. 

Ordering assistance 

Email PDF elevations or sections to info@hbelementsinc.com for a proposal, or call HB at (954) 784-8216. Standard measurements are in the Rafter Tails Spec Sheet, and the HB rafter tails page lists the whole range.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″