RT-4470-6

RT-4470-6 is a PVC rafter tail with a deep slanted step about a third of the way out, a long bowed curve and a pronounced notch that leaves a square ledge under the tip. It is the longer-curved partner to RT-4470-3, giving a lighter, more drawn-out profile. Nine standard sizes for HB soffit systems or standalone use. 

SKU: RT-4470-6 Category: Tag:
Description

RT-4470-6 PVC Rafter Tail 

The same cuts can look heavy or light depending on where they start. RT-4470-6 moves its deep step well toward the wall, so the curve that follows has room to stretch across most of the tail before ending in a crisp notch. It is a decorative cellular PVC tail that gives eaves the look of exposed rafters.  

A long curve between two firm cuts 

After about a third of its length at full height, RT-4470-6 drops into a deep slanted step. A bowed curve then rises across the rest of the tail, quickest at the start and easing toward the end, where it stops at a pronounced notch that leaves a square ledge beneath the tip. 

Its sibling RT-4470-3 holds full depth past mid-length and has a short curve. RT-4441-6 starts in the same place but lets its curve rise almost to the top, ending in a much smaller notch. RT-4470-6 suits coastal, Key West and West Indies homes with generous overhangs, and also works at gable ends or under a deck.  

Construction 

RT-4470-6 is cellular PVC with a hollow core, formed on HB Elements’ patented fabrication system. It is decorative and should never be used to carry weight. 

Installers get a cleat and adhesive with every tail. Trim it if your overhang is short, then fix it against cellular PVC soffit or over stucco, wood or cement fiber; it paints well after a light prep.  

With HB soffit panels 

A long, light tail like this sits well over a V-groove ceiling such as VGP-5-10, where it also covers the joints between panels. HB fascia and frieze board finish the soffit ceilings system; tails can be ordered on their own.

Ordering and sizing help 

Email a PDF set of plans to info@hbelementsinc.com or call (954) 784-8216 for a size recommendation. The Rafter Tails Spec Sheet lists standard dimensions, and the rafter tails page shows all profiles.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″