

RT-4460-4
RT-4460-4 is a PVC rafter tail whose underside breaks at a crisp angle about a third of the way out, rises in a bowed curve and finishes at a small notch beneath the square tip. There is no step at the start, so the curve grows straight from the body. Nine standard sizes for HB soffit systems or standalone use.
RT-4460-4 PVC Rafter Tail
Without a step at its start, a curve looks as though it was shaped from the solid rafter rather than cut into it. RT-4460-4 takes that cleaner approach and adds a notch only at the tip. It is a decorative tail in cellular PVC that recreates the look of exposed rafter ends.
An angled break and a notched end
For about a third of its length RT-4460-4 is plain and full height. The underside then turns upward at a crisp angle and continues in a bowed curve, rising steeply at first and flattening near the end, where a small notch leaves a short ledge under the square tip.
It is RT-4401-5 with a notched tip added; that tail runs its bowed curve straight to a square end. For a deep step at the start of a similar curve and notch, see RT-4441-6. RT-4460-4 suits coastal, Mediterranean and Florida Vernacular homes and can also be used for gable lookouts or under a deck.
Construction details
RT-4460-4 is hollow-core cellular PVC made on HB Elements’ patented fabrication system. It is non-structural.
Fixing hardware (a cleat and adhesive) is packed with every tail. On a short overhang the tail can be cut down on site; it then goes up against cellular PVC soffit or over stucco, wood or cement fiber, ready for paint with very little preparation.
Completing the soffit
Run RT-4460-4 over HB panels such as the NJP-5-10 nickel joint panel to cover panel joints and add a steady rhythm along the eave. Fascia and frieze board from HB finish the HB PVC soffit system, and the tails can be bought separately.
Ordering and sizing help
Not sure which size fits? Email plans as a PDF to info@hbelementsinc.com or call (954) 784-8216. Standard tail dimensions are collected in the Rafter Tails Spec Sheet, and the rafter tails page lets you compare profiles side by side.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
