

RT-4293-4
RT-4293-4 is a multi-cut PVC rafter tail: three small square steps grouped around mid-length lead into a concave curve that rises to a notch beneath the square tip. Clustering the steps gives a strong band of shadow in the middle of the tail, framed by plain body and a curved end. Nine sizes for HB soffit systems or standalone use.
RT-4293-4 PVC Rafter Tail
Grouping several small cuts together creates a concentrated burst of detail, much like the stepped moldings on traditional cornices. RT-4293-4 places three steps close together near the middle of its underside, then finishes with a curve and notch. It is an ornamental cellular PVC tail that gives the eave the appearance of exposed rafter ends.
A cluster of steps and a curved end
RT-4293-4 stays at full height for about a third of its length. Three small square steps then follow one another in quick succession, each lifting the underside a little more. From the last step, a concave curve climbs toward the end and stops at a notch, leaving a short ledge beneath the square tip.
Its sibling RT-4293-7 moves the same three steps toward the wall, giving a longer curve. For a version with two widely spaced steps, see RT-4290-7. RT-4293-4 suits British West Indies, Key West and coastal homes where the eave is meant to catch the eye, and also works on gable lookouts or beneath a deck.
Construction
HB Elements produces RT-4293-4 in hollow-core cellular PVC on its patented fabrication system. It is an ornamental piece with no structural role.
Every tail ships with a cleat and adhesive. It can be cut shorter during installation and fixed over cellular PVC soffit, stucco, wood or cement fiber, needing only light prep before paint.
Pairing with HB panels
Because the stepped cluster is busy, a smooth ceiling such as SMP-5-10 lets it stand out. The tails also conceal the panel seams. Add HB fascia and frieze board from the soffit ceilings range for a finished eave, or order the tails alone.
Ordering and sizing help
For a sizing recommendation, email PDF drawings to info@hbelementsinc.com or call (954) 784-8216. Standard dimensions are listed in the Rafter Tails Spec Sheet, and more profiles are on the rafter tails page.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
