RT-4220-4

RT-4220-4 is a PVC rafter tail with a shallow slanted step about a third of the way along and a rounded end that stops at a short square face at the tip. Keeping a flat face at the end gives the curve a firmer, more finished look. Nine sizes are available for HB soffit systems or standalone installation.

SKU: RT-4220-4 Category: Tag:
Description

RT-4220-4 PVC Rafter Tail 

Some rounded rafter ends roll all the way to the top; others stop short and leave a small flat face at the tip. RT-4220-4 is the second type, combining a soft curve with a crisp end. This cellular PVC tail is purely ornamental, reproducing exposed rafter ends below the eave without playing any part in the roof structure.  

A rounded end with a square face 

RT-4220-4 is full depth for about a third of its length before a shallow slanted step lifts the underside. It then runs level until near the end, where the underside curves upward in a convex arc. Rather than meeting the top edge, the curve ends at a short vertical face, so the tip finishes square. 

It shares its step with RT-4210-4, whose rounded end rolls right up to the top edge. The square face on RT-4220-4 makes the end look a little heavier and more defined. For a version with two steps before the curve, see RT-4221-5. It suits coastal, Craftsman and British West Indies homes, and can also be used for gable lookouts or under cantilevered decks.  

Construction details 

The tail is made by HB Elements in hollow-core cellular PVC through its patented fabrication system. It is ornamental and should not be used structurally. 

Each tail comes with a cleat and adhesive. It can be trimmed to a shorter length on site and mounted on cellular PVC soffit or on stucco, wood or cement fiber. Very little prep is needed before painting.  

With HB soffit panels 

Set over a smooth ceiling such as SMP-5-08, the rounded ends stand out clearly, while the tails mask the seams between panels. HB fascia and frieze board round off the full soffit system; the tails can also be ordered separately.

Ordering and sizing help 

Send PDF plans to info@hbelementsinc.com or call HB on (954) 784-8216 for help with sizes and quantities. Every standard size is listed in the Rafter Tails Spec Sheet, and you can compare designs on the rafter tails page. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″