RT-4203-1

RT-4203-1 is a round-ended PVC rafter tail: its straight body finishes in a smooth convex curve that rolls from the underside up to the top edge. The uncluttered profile gives a row of tails a soft, even rhythm beneath the eave. Offered in nine sizes for HB soffit systems or standalone installation. 

SKU: RT-4203-1 Category: Tag:
Description

RT-4203-1 PVC Rafter Tail 

Round-ended rafter tails have long been used to soften the edge of a roof, especially on homes where crisp angles would feel too severe. RT-4203-1 is one of HB’s round-ended designs, made in cellular PVC. It is a decorative tail that gives the overhang the look of exposed rafters without forming part of the roof structure.  

A smoothly rolled end 

RT-4203-1 has a straight top and a straight underside along most of its length. At the end, the underside rolls upward in a smooth convex curve that carries all the way to the top edge, so the tip has no flat face. 

Other HB tails with a rounded end include RT-4200-1, as well as RT-4204-1 and RT-4205-5, which add a small notch on the underside. RT-4203-1 suits coastal, Craftsman and Florida Vernacular homes and can be used at gable ends or under cantilevered decks. HB can help you decide which rounded profile best fits your elevations.  

Material 

The tail is hollow-core cellular PVC produced with HB Elements’ patented fabrication system. It is trim only and is not rated to carry loads. 

A cleat and adhesive are included. Trim the tail on site if needed and fit it to cellular PVC soffit, stucco, wood or cement fiber; it requires very little prep before painting.  

With HB soffit panels 

A smooth panel such as SMP-5-12 keeps the overall look clean, while grooved panels add more texture. Either way, the tails cover the panel joints. Add HB fascia and frieze board to complete the soffit system, or order the tails individually.

Ordering and sizing help 

Email your plans in PDF format to info@hbelementsinc.com or call HB on (954) 784-8216 for sizing help. Dimensions are in the Rafter Tails Spec Sheet; compare profiles on the rafter tails page.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″