

RT-4083-5
RT-4083-5 is a PVC rafter tail with a slanted step about a third of the way along, a brief level section and then a long, shallow slope ending in a small notch under the square tip. Starting the detail early stretches the slope across most of the exposed tail. Nine sizes for HB soffit systems or standalone use.
RT-4083-5 PVC Rafter Tail
Moving the first cut of a rafter tail closer to the wall changes its whole character, turning a compact end detail into a long, flowing line. RT-4083-5 does exactly that with the step, slope and notch sequence HB uses on several tails. It is a decorative cellular PVC element that gives the eave the look of exposed rafter ends.
An early step and a long slope
About a third of the way out, RT-4083-5 steps up at a small slanted cut and runs level for a short distance. From there the underside climbs in a long, shallow slope that occupies most of the remaining length, ending at a small notch below the tip. The tip itself is square, and the top edge stays straight.
Its sibling RT-4083-3 begins the same sequence at mid-length, so its slope is shorter and steeper. Choose RT-4083-5 when you want a slimmer, more drawn-out tail, for instance on low, broad eaves of coastal and Key West homes. For a long slope with an early square step instead of a slanted one, see RT-4082-6. It can also be used at gable ends or under a cantilevered deck.
Material
RT-4083-5 is formed in hollow-core cellular PVC using the patented system HB Elements developed for its rafter tails. It is non-structural and intended only as decorative trim.
Each tail comes with a cleat and adhesive. Shorten it during installation if necessary, then fix it to cellular PVC soffit, stucco, wood or cement fiber. It needs very little preparation before it is painted.
Pairing with HB panels
Set over a smooth ceiling such as SMP-5-10, the long slope of RT-4083-5 stands out clearly, and the tails conceal the panel joints. HB fascia and frieze board finish the PVC soffit system; all items can be bought individually.
Ordering and sizing help
Send your plans to info@hbelementsinc.com as a PDF, then call (954) 784-8216 to finalize sizes with HB. The Rafter Tails Spec Sheet lists standard dimensions; the rafter tails collection shows every profile.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
