RT-4003-1

RT-4003-1 is one of HB Elements’ simplest PVC rafter tails: a plain rectangular body finished with a single long bevel that rises from the underside to a short, square tip. With no steps or curves, it gives exposed eaves a calm, understated rhythm. Nine sizes; works with the HB PVC Soffit System or alone.

SKU: RT-4003-1 Category: Tag:
Description

RT-4003-1 PVC Rafter Tail 

Not every roofline needs a carved or scrolled tail. Sometimes the best detail is the one closest to plain sawn lumber, a rafter end trimmed with one clean angled cut. RT-4003-1 delivers exactly that in cellular PVC. It is a decorative piece that gives the overhang the look of exposed rafters, while the real roof framing stays hidden above the soffit.  

One clean bevel 

The top and bottom edges of RT-4003-1 run straight and parallel for most of its length. Near the end, the underside turns upward in a single long diagonal that stops at a short vertical face at the top, forming the square tip. There are no notches, steps or curves anywhere along the profile. 

That restraint lets the tails read as honest framing rather than ornament, which suits the simpler Florida Vernacular, Key West and coastal homes in HB’s portfolio. Use it along the eaves, at a gable as a lookout, or beneath a cantilevered deck. If you want the same angled end with a little more detail, see RT-4011-5, which adds a square step on the underside before the cut.  

Materials and fitting 

Like all HB rafter tails, RT-4003-1 has a hollow cellular PVC core and is built with HB’s patented fabrication process. It is not load-bearing and should only be used as trim. 

Each tail ships with a cleat and adhesive. If your overhang calls for a shorter piece, cut it down on site with standard woodworking tools. Fix it over stucco, wood or cement fiber, or, as is most common, against cellular PVC soffit, then paint it with the rest of the trim; very little surface prep is required.  

Pair it with HB soffit panels 

Plain tails like this one look especially at home under a grooved soffit. Combine RT-4003-1 with an HB panel such as the NJP-5-10 nickel joint panel, plus fascia and frieze board, to build the full HB PVC soffit system. Placing the tails over the panel seams helps conceal them. Every component can also be ordered separately.

Ordering and sizing help 

Email a PDF of your plans to info@hbelementsinc.com or call (954) 784-8216 and an HB representative will help you choose sizes and quantities. The Rafter Tails Spec Sheet lists all standard dimensions, and the rafter tails page shows the full profile library. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″