

RT-4003-5
RT-4003-5 is a PVC rafter tail with a long, gradual taper: about halfway along, the underside angles gently upward and runs to a short, square tip. The result is a slender, streamlined end that lightens the look of an overhang. Offered in nine sizes for the HB PVC Soffit System or standalone use.
RT-4003-5 PVC Rafter Tail
Seen from the street, a deep rafter tail can make an eave look heavy. Tapering the underside is the traditional carpenter’s answer, and RT-4003-5 takes that idea further than most: the slope begins well back from the end, so the tail thins out over a long distance. Made from cellular PVC, it is purely decorative and creates the appearance of exposed rafter ends beneath the roof.
A long, gentle taper
For roughly the first half of its length, RT-4003-5 is a plain rectangular block. From there, the underside angles upward in one long, low slope that carries all the way to the end, where it meets a short vertical face below the straight top edge. With no steps or curves, the profile reads as a single sweeping line.
Compared with RT-4003-1, which uses a short, steep bevel close to the tip, RT-4003-5 spreads the angle over a much longer distance, giving a more tapered, streamlined look along the eave. That lighter appearance can help on homes with wide overhangs or several rows of tails, and it fits the coastal, Key West and West Indies styles HB is known for. The tail also works as a lookout at gable ends or under a cantilevered deck.
Construction
The tail is made with HB Elements’ patented fabrication system and has a hollow cellular PVC core. It is decorative only and is not designed to carry structural loads.
Installation uses the cleat and adhesive supplied with each piece. The tail can be shortened on site if necessary and can be mounted over stucco, wood, cement fiber or, most commonly, cellular PVC soffit. It needs little prep before painting.
Part of a complete PVC soffit
Run a line of RT-4003-5 tails over HB soffit panels, for example the beveled VGP-5-10 V-groove panel, and finish the edge and wall line with HB fascia and frieze board. Together they form the HB PVC soffit system, in which the tails also help cover panel seams. Each piece is available individually if you only need tails.
Part of a complete PVC soffit
Run a line of RT-4003-5 tails over HB soffit panels, for example the beveled VGP-5-10 V-groove panel, and finish the edge and wall line with HB fascia and frieze board. Together they form the HB PVC soffit system, in which the tails also help cover panel seams. Each piece is available individually if you only need tails.
Ordering and sizing help
For help choosing sizes, send your plans as a PDF to info@hbelementsinc.com or speak to HB on (954) 784-8216. Full dimensions are in the Rafter Tails Spec Sheet, and you can compare other profiles on the HB rafter tails page.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
