

RT-4003-9
RT-4003-9 is a wedge-shaped PVC rafter tail: its underside begins to slope close to the wall end and keeps rising for most of the tail’s length to a narrow, square tip. It gives the slimmest, most streamlined line of HB’s plain tapered tails. Nine sizes; use it with the HB PVC Soffit System or on its own.
RT-4003-9 PVC Rafter Tail
Some rooflines call for a rafter end that almost disappears into the eave. RT-4003-9 does that by tapering over nearly its whole length, so the depth you see at the wall shrinks steadily to a slim tip at the end. It is a decorative cellular PVC piece that recreates exposed rafter ends; the actual roof framing remains concealed.
A nearly full-length wedge
Only a short section of RT-4003-9 near the wall keeps the full rectangular depth. Soon after, the underside angles upward in one continuous, shallow line that runs almost the entire length of the tail and finishes at a short vertical face beneath the flat top. The result is a long, wedge-like silhouette with no steps, notches or curves.
RT-4003-9 belongs to a family of three plain tapered tails. RT-4003-1 bevels steeply just behind the tip, RT-4003-5 starts its slope around the midpoint, and RT-4003-9 tapers the furthest. Choose it when you want tails that look light and fine-boned, for instance under a wide, low overhang on a coastal or Key West-style home, at gable-end lookouts or beneath a cantilevered balcony.
Build and installation
Each tail is produced by HB Elements using its patented fabrication system, with a hollow core of cellular PVC. It is an ornamental piece, not a structural one.
A cleat and adhesive come with every tail. It can be cut shorter on the job if the overhang requires, and fixed to stucco, wood, cement fiber or, most often, cellular PVC soffit. Once fitted, it needs very little preparation before it is painted along with the surrounding trim.
Combining tails with soffit panels
A slender tail like this pairs well with a quiet soffit surface such as HB’s SMP-5-08 smooth panel, or with grooved panels if you prefer more pattern. Add fascia and frieze board to complete the HB PVC soffit system; installed together, the tails cover the panel seams. All components are sold separately as well.
Ordering and sizing help
Email HB a PDF of the plans at info@hbelementsinc.com or phone (954) 784-8216 to confirm sizes and quantities. See the Rafter Tails Spec Sheet for standard dimensions and the rafter tail collection for other profiles.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
