RT-4010-9

RT-4010-9 is a long, slender PVC rafter tail: a small slanted step near the wall end starts a straight slope that runs for most of the tail’s length to a square tip. The early step and extended taper give eaves a light, drawn-out profile. Nine sizes, suited to HB soffit systems or use on its own.

SKU: RT-4010-9 Category: Tag:
Description

RT-4010-9 PVC Rafter Tail 

On wide, shallow-pitched overhangs, a tail that keeps its full depth all the way out can look bulky. RT-4010-9 solves this by starting its shaping almost at the wall, so most of what you see from below is a slim, rising taper. Like all HB rafter tails it is a decorative PVC element that recreates exposed rafter ends, not a structural member. 

An early step and an extended taper 

Only a short length of RT-4010-9 near the wall keeps the full rectangular depth. There, a small step with a slanted face is cut into the underside, and from it a straight slope climbs steadily over roughly three-quarters of the tail to a short vertical face at the tip. The top edge stays level the whole way. 

It uses the same slanted step as RT-4010-5, but moves it much closer to the wall, so the taper is about half as long again. For a similar long taper with no step at all, see RT-4003-9. RT-4010-9 suits low, wide eaves on coastal, West Indies and Key West-style homes, and can also be used for gable lookouts or under a cantilevered deck. 

Construction details 

HB Elements makes RT-4010-9 from cellular PVC with a hollow core, using its patented fabrication system. It is an ornamental tail and is not rated for structural use. 

Each tail comes with a cleat and adhesive for fixing. It can be trimmed to length on site and mounted over stucco, wood, cement fiber or, most typically, cellular PVC soffit, then painted after minimal prep. 

Working with HB soffit panels 

Run RT-4010-9 across a ceiling of HB panels, for example the shiplap VGP-SL-5-12 V-groove panel, to cover seams and add a timber-framed rhythm. With HB fascia and frieze board the result is a complete PVC soffit system; the tails are also sold separately. 

Ordering and sizing help 

Email a PDF of the drawings to info@hbelementsinc.com or call HB’s office on (954) 784-8216 to choose sizes. Dimensions are listed in the Rafter Tails Spec Sheet, and you can compare profiles on the rafter tails page. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″