RT-4010-5

RT-4010-5 is a PVC rafter tail with a small, slanted step cut into the underside about halfway along; from that step, the underside rises in one straight slope to a square tip. The step acts like a subtle joint line, giving a long beveled end a crafted finish. Available in nine sizes for use with HB soffit systems or on its own. 

SKU: RT-4010-5 Category: Tag:
Description

RT-4010-5 PVC Rafter Tail 

A long bevel on a rafter end can look a little bare; a small cut where the bevel begins gives it a clear starting point. RT-4010-5 uses that idea, marking the start of its slope with a compact, angled step. It is a decorative PVC tail that gives eaves the appearance of exposed rafter ends, with the true framing hidden behind the soffit. 

A slanted step that starts the slope 

Up to its midpoint, RT-4010-5 is a straight, full-depth block with a flat top. Midway along, a small step with a slanted face is cut into the underside. The slope starts right at that step and rises in a single straight line to a short vertical face at the tip, with no level section in between. 

Because the step leads straight into the bevel, the end reads as one continuous shape with a defined edge, rather than a series of separate cuts like RT-4005-7. If you prefer a square notch at the start of the slope, compare RT-4004-3. A related profile, RT-4010-9, is also available. RT-4010-5 fits coastal, Key West and Florida Vernacular rooflines and can also be used at gable-end lookouts or below a cantilevered deck. 

Made from cellular PVC 

The tail is built by HB Elements from cellular PVC around a hollow core, using the company’s patented fabrication system. It is purely decorative and must not be used to support any load. 

Installation is straightforward with the cleat and adhesive provided. The tail can be cut down on site, fixed over stucco, wood, cement fiber or, most often, cellular PVC soffit, and then painted with little preparation. 

Completing the soffit 

Fitted across HB soffit panels, such as the SMP-5-10 smooth panel or a grooved alternative, a row of RT-4010-5 tails conceals panel seams and creates a timber-framed rhythm along the eave. Add HB fascia and frieze board for the complete PVC soffit system, or purchase the tails alone.

Ordering and sizing help 

To order, email a PDF set of drawings to info@hbelementsinc.com and call (954) 784-8216 to go through sizes with the team. Standard measurements are in the Rafter Tails Spec Sheet, and more designs are on the HB rafter tails page. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″