RT-4683-7

RT-4683-7 is a PVC rafter tail with a small step near the wall, followed by an underside that rises in one long, gradual curve to a notch under the square tip. Nine standard sizes for HB soffit systems or standalone installation. 

SKU: RT-4683-7 Category: Tags: ,
Description

RT-4683-7 PVC Rafter Tail 

Instead of a sharp wave, RT-4683-7 uses a slow, continuous rise that runs almost the full length of the tail. A small step near the wall starts it and a notch at the tip closes it. The effect is soft and tapering, achieved in decorative cellular PVC rather than structural timber. 

A long, tapering rise 

Roughly a fifth of the way from the wall, the underside of RT-4683-7 drops a small step. From that point it climbs steadily in a gentle, drawn-out curve, thinning the tail toward the end, and finishes at a notch under the square tip beneath the straight top edge. 

Compare RT-4680-6, which holds a near-level run after its step and saves the curve for the outer third. RT-4601-7 has a similar long sweep but no step or tip notch. The tapering line suits low-slope roofs, ranch and coastal homes, and pool or patio covers. 

Material and attachment 

Made by HB Elements from hollow-core cellular PVC using its patented method, RT-4683-7 is a non-structural trim piece. 

A cleat and adhesive are supplied. Trim the tail where the eave is shallow, then secure it to cellular PVC soffit, stucco, wood or cement fiber. A wipe-down is enough prep for paint. 

Soffit ceiling pairing 

Beneath a slatted V-groove soffit such as VGP-SL-5-12, the tapering tails contrast with the straight grooves and hide the panel seams. Fascia and frieze board round out HB’s soffit ceilings selection; the tail is available on its own as well.

Ordering support 

For size advice, email PDF elevations or sections to info@hbelementsinc.com or phone (954) 784-8216. Standard dimensions are on the Rafter Tails Spec Sheet, and the complete range is on the HB rafter tails page.