RT-4601-7

RT-4601-7 is a PVC rafter tail whose underside flows in one long S-shaped wave, starting close to the wall and running almost the full length to a slim square tip. With no steps or notches, it is the smoothest, most fluid of HB’s wave tails. Nine standard sizes for HB soffit systems or standalone use. 

SKU: RT-4601-7 Category: Tag:
Description

RT-4601-7 PVC Rafter Tail 

Stretching a wave across nearly the whole rafter tail turns it into a single, unbroken line beneath the eave. RT-4601-7 does exactly that, with nothing to interrupt the curve. Made in cellular PVC, it is decorative trim that gives the overhang the look of exposed rafters.  

One long, unbroken wave 

Only a short section of RT-4601-7 near the wall keeps its full height. From there the underside dips into a hollow curve, then rolls over and rises in a long, gentle sweep to a slim square tip beneath the straight top edge. There are no steps or notches anywhere along it. 

It is the extended version of RT-4601-2, which saves the same kind of wave for the last part of a plain tail. For a similar long wave introduced by a small notch, see RT-4602-6. RT-4601-7 suits coastal, Key West and West Indies homes with wide, low eaves, and also works at gable ends or beneath a deck.  

Construction 

Cellular PVC with a hollow center is the material; HB Elements shapes it on a patented system developed for its tails. Think of RT-4601-7 as cosmetic: it adds character, not strength. 

Out of the box you get the tail, a cleat and adhesive. A saw cut shortens it if your eave calls for less projection. Cellular PVC soffit is the usual backing, but stucco, wood and cement fiber work too, and paint goes straight on after a wipe-down.  

With HB soffit panels 

Over a V-groove ceiling such as VGP-5-12, the long waves soften the straight grooves, and the tails cover the panel seams. HB fascia and frieze board finish the soffit ceilings system; tails are sold on their own too.   

Ordering and sizing help 

Ask HB to size it for you by emailing a PDF of the elevations to info@hbelementsinc.com; a follow-up call to (954) 784-8216 settles quantities. Profiles and dimensions are summed up in the Rafter Tails Spec Sheet and illustrated on the rafter tails page.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″