RT-4501-5

RT-4501-5 is a PVC rafter tail with a half-round arch cut into its underside, starting at a step about a third of the way out and finishing against a deep, square end block. The arch reads like a small opening beneath the rafter, a distinctive look among HB’s tails. Nine standard sizes for HB soffit systems or standalone use. 

SKU: RT-4501-5 Category: Tag:
Description

RT-4501-5 PVC Rafter Tail 

Most rafter tails thin out toward the tip. RT-4501-5 does something different: it carves a half-round arch out of the underside and then returns to a deep, square end, so the tip keeps real weight. It is a decorative cellular PVC tail that adds the look of exposed rafter ends to an eave.  

An arch with a solid end 

RT-4501-5 is full height for about a third of its length. A step then opens into a smooth half-round arch that rises high into the tail, levels off, and curves back down toward the end, finishing at a deep square block beneath the straight top edge. 

Because the end stays deep, RT-4501-5 looks heavier at the tip than curved tails such as RT-4201-3, whose curve thins the end. For an arched underside with an angled, pointed end instead of a square one, see RT-4505-4. RT-4501-5 suits Spanish Mediterranean, British West Indies and coastal homes, and can also be used at gable ends or under a cantilevered deck.  

How it is made 

RT-4501-5 is fabricated by HB Elements in hollow-core cellular PVC using its patented process. It is trim and carries no structural load. 

Installation uses the cleat and adhesive supplied. The tail can be trimmed on site and fixed over cellular PVC soffit, stucco, wood or cement fiber, then painted after minimal prep.  

Completing the soffit 

Run RT-4501-5 over HB panels such as the NJP-5-12 nickel joint panel, so the arched tails frame the grooves and hide the panel seams. HB fascia and frieze board finish the soffit system; each part is available alone. 

Ordering and sizing help 

For sizing help, email a PDF of your plans to info@hbelementsinc.com or call (954) 784-8216. Standard sizes are in the Rafter Tails Spec Sheet, and more designs are on the rafter tails collection page.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″