RT-4070-4

RT-4070-4 is a PVC rafter tail with a step at both ends of its taper: a slanted step part-way along starts the slope, and a small notch just under the square tip finishes it. The paired steps give the end a bold, carved character. Available in nine sizes for HB soffit systems or for use on its own. 

SKU: RT-4070-4 Category: Tag:
Description

RT-4070-4 PVC Rafter Tail 

Bracketing a slope with a cut at each end is a classic way to make a simple rafter taper look hand-worked. RT-4070-4 applies that idea in cellular PVC, so the angled section of each tail stands out clearly against the soffit. It is a decorative tail that recreates exposed rafter ends; the structural framing stays hidden above the ceiling. 

A step at each end of the slope 

RT-4070-4 has a straight top and runs at full depth for a little under half its length. A small step with a slanted face then breaks the underside and starts a straight, moderate slope. Near the end, the slope meets a second small notch, leaving a short, shallow section at the square tip. 

Each of its details appears separately on other HB tails: RT-4010-5 has the slanted step before the slope, and RT-4060-4 has the notch under the tip. RT-4070-4 uses both, giving it more definition from below. It suits coastal, Key West and British West Indies homes where the eave detail should be noticed, and can also be used as a gable-end lookout or under a cantilevered deck. A related profile, RT-4080-5, is also available. 

Material and installation 

RT-4070-4 is produced in hollow-core cellular PVC through HB Elements’ patented fabrication system. It is non-structural and serves only as architectural trim. 

Each tail is packed with a cleat and adhesive. It can be cut to length on site and fixed over stucco, wood, cement fiber or, most commonly, cellular PVC soffit. Little preparation is needed before painting. 

Building the full soffit 

Combine RT-4070-4 with HB soffit panels, for example the VGP-5-10 V-groove panel, so the tails cover panel seams and add a timber-framed pattern to the overhang. Add HB fascia and frieze board to complete the PVC soffit system, or order the tails individually.

Ordering and sizing help 

Email PDF plans to info@hbelementsinc.com or call HB at (954) 784-8216 for help with sizes and quantities. The Rafter Tails Spec Sheet lists standard dimensions, and the HB rafter tails page shows the full range. 

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″