

RT-4250-4
RT-4250-4 is a PVC rafter tail that combines a slanted step about a third along, a rounded convex end and a small notch under the square tip. The notch caps the curve with a crisp ledge, giving the soft end a more tailored finish. Nine sizes for HB soffit systems or standalone use.
RT-4250-4 PVC Rafter Tail
A rounded rafter end can finish smoothly, flat, or with a small ledge at the top. RT-4250-4 takes the third approach, adding a notch where the curve meets the tip. It is an ornamental cellular PVC tail that gives eaves the look of exposed rafter ends, with no part in the roof’s structure.
A rounded end capped by a notch
A slanted step roughly one third along is the first change on RT-4250-4’s underside. After a level stretch, the bottom edge bends up in a convex arc toward the tip, and a small notch at the top of that arc leaves a square-ended ledge beneath the flat top.
Its rounded relatives finish differently: RT-4220-4 stops its curve at a plain square face, and RT-4210-4 rolls the curve right to the top edge. The notch on RT-4250-4 adds an extra line of shadow at the tip, which works well on Key West, Low Country and coastal elevations. It also works for gable lookouts and under cantilevered decks.
How it is made
RT-4250-4 is cellular PVC with a hollow core, made on HB Elements’ patented fabrication system. It is non-structural trim.
The supplied cleat and adhesive are used for installation. Trim the tail on site if required and fix it to cellular PVC soffit, stucco, wood or cement fiber. It is ready to paint after light prep.
Pairing with soffit panels
Over a V-groove ceiling such as VGP-5-12, RT-4250-4 tails cover the panel joints and add a soft, timber-framed rhythm. To finish the overhang, add HB fascia and frieze board from the PVC soffit system; tails are also sold as a separate item.
Ordering and sizing help
Share your plans with HB as a PDF at info@hbelementsinc.com or call (954) 784-8216 to choose sizes. Size data for every standard tail is in the Rafter Tails Spec Sheet, and the wider range is on the rafter tails page.
| soffit-systems-variations | 3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″ |
|---|
