RT-4090-5

RT-4090-5 is a three-cut PVC rafter tail: a slanted step about a third along, a second slanted step past the midpoint and a final notch under the square tip, with gentle slopes between them. The repeated cuts give the underside a stepped, carved rhythm. Nine sizes, for HB soffit systems or use on its own.

SKU: RT-4090-5 Category: Tag:
Description

RT-4090-5 PVC Rafter Tail 

Repeating the same cut several times along a rafter end creates a rhythm that a single step cannot. RT-4090-5 uses three cuts spaced along its underside, each joined to the next by a short slope, so the tail climbs toward its tip in stages. It is a decorative tail in cellular PVC that adds the appearance of exposed rafters to an eave.  

Three cuts, climbing in stages 

The tail is full depth for about the first third. A slanted step then lifts the underside, which rises gently to a second slanted step a little past the midpoint. A further slope carries the underside up to a small notch just below the tip, and the tail ends square beneath a straight top edge. 

Where RT-4022-8 climbs in three square steps separated by level runs, RT-4090-5 uses slanted steps linked by slopes, so it reads as a continuous ascent rather than a staircase. Compared with RT-4070-4, it adds an extra cut in the middle. It suits British West Indies, coastal and Key West homes where the eave detail is meant to be a feature, and also works for gable lookouts or beneath a cantilevered deck.  

Construction 

RT-4090-5 is made by HB Elements in hollow-core cellular PVC with its patented fabrication system. It is a decorative component and not suitable for structural use. 

A cleat and adhesive are included for fixing. The tail can be cut shorter on site and installed over cellular PVC soffit, stucco, wood or cement fiber, then painted after light preparation.  

With HB soffit panels 

Because the profile is busy, it pairs well with a calm ceiling such as the SMP-5-12 smooth panel. The tails cover the panel joints as they are installed. Add HB fascia and frieze board for the complete soffit system, or order RT-4090-5 on its own.

Ordering and sizing help 

For a quote, send PDF drawings to info@hbelementsinc.com or call (954) 784-8216 to talk through sizes. Standard dimensions are listed on the Rafter Tails Spec Sheet, and every design is on the HB rafter tails page.

Additional information
soffit-systems-variations3 1/2″ x 5 1/2″ x 24″, 3 1/2″ x 5 1/2″ x 30″, 3 1/2″ x 5 1/2″ x 36″, 4 1/2″ x 9 1/2″ x 24″, 4 1/2″ x 9 1/2″ x 30″, 4 1/2″ x 9 1/2″ x 36″, 4″ x 7 1/2″ x 24″, 4″ x 7 1/2″ x 30″, 4″ x 7 1/2″ x 36″