

VGP-5-10
VGP-5-10 is HB Elements’ 10-foot V-groove soffit panel, made from 1/2″ cellular PVC with beveled V-joints at 5″ centers that look like traditional tongue-and-groove boards. A practical length for most eaves and porch ceilings. Seven widths from 12″ to 48″.
VGP-5-10 V-Groove PVC Soffit Panel (10 ft)
VGP-5-10 is the mid-length option in HB’s V-groove line and a common choice for full-house soffits. Ten feet covers more of an eave per sheet than the 8-foot panel, while remaining easier to raise and fasten than a 12-foot one. The beveled grooves give the familiar board-ceiling pattern without the upkeep of wood.
Tongue-and-groove pattern in one sheet
VGP-5-10 reproduces V-joint tongue-and-groove soffit with chamfered grooves running lengthwise every 5″, matching the spacing of 1×6 boards. The flat areas between grooves are smooth and paint-ready rather than woodgrain-textured. Under rafter tails, the result resembles exposed roof decking on a timber-framed home.
If you prefer a squared shadow line, use NJP-5-10; for a plain ceiling, SMP-5-10. For the shiplap version, see VGP-SL-5-10.
Planning runs with 10-foot panels
Measure each eave and porch ceiling and decide groove direction before ordering; 10-foot sheets work out cleanly on 20- and 30-foot runs. Grooves help disguise end joints, and HB rafter tails can sit over panel seams. HB says its sheets are fully usable, with far less waste than the typical 20% factor of other soffit materials.
For tight spots, the 8-foot VGP-5-08 is easier to handle; on long eaves, the 12-foot VGP-5-12 cuts the number of joints.
Cellular PVC construction
The panel is cellular PVC, which HB says will not split, check, crack or rot, has no expansion and contraction, and holds paint about five times longer than wood. A factory woodgrain finish in several stains is offered. Use VGP-5-10 with fascia, frieze board and HB PVC rafter tails as a complete soffit ceiling, on its own, or as vertical or horizontal wall cladding.
Ordering and sizing help
Send a PDF set of plans to info@hbelementsinc.com and phone (954) 784-8216 to agree widths and quantities with HB. Standard sizes for every panel style are in the Soffit Panels Spec Sheet.
| soffit-systems-variations | V-groove panel – 1/2″ x 12″ x 10′, V-groove panel – 1/2″ x 18″ x 10′, V-groove panel – 1/2″ x 24″ x 10′, V-groove panel – 1/2″ x 30″ x 10′, V-groove panel – 1/2″ x 36″ x 10′, V-groove panel – 1/2″ x 42″ x 10′, V-groove panel – 1/2″ x 48″ x 10′ |
|---|
